Keyence VT3-Q5SW Front Overlay Touch Glass Repair

FAQ:

Question: What should I pay attention to when installing the emergency stop switch?

Answer:
• For the installation and wiring of emergency stop switch, one of the following operations must work: for mechanical equipment that might cause dangerous state, cut off power supply of the actuator immediately(stop category 0), or control power suppl of the actuator y(stop category 1), so as to stop the dangerous running as soon as possible.
• When emergency stop switch is pressed,emergency stop must have priority over other functions,and all operating modes.
• The emergency stop switch should be installed and wired such that it will not automatically return (restarted)even if it is reset.
• The emergency stop switch should be set up and wired such that operators have the easiest access to it in case of emergency.

Question: How do I use the cable for terminal block？

Answer:
1.When twisted cable or single cable is processed directly: Confirm the end of the twisted cable is not exposed. Cannot galvanize for the end of cable.
2. When rod terminal with insulating sleeve is used: The cable may be not easy to insert into the insulating sleeve due to different thicknesses of cable sheath,then please select proper cable according to the outline dimension diagram.