PPC-174T-BARE-C HMI Touch Glass Protective Film Repair

Warnings

1. For plug-in equipment, the power outlet socket must be located near the equipment and must be easily accessible.
2. Keep HMI Avantech PPC-174T-BARE-C Touch Membrane Front Overlay away from humidity.
3. Make sure the voltage of the power source is correct before connecting the equipment to the power outlet.
4. Put Advantech touch screen PPC-174T-BARE-C Protective Film MMI Panel Glass on a reliable surface during installation. Dropping it or letting it fall may cause damage.
5. Never open the equipment. For safety reasons, the equipment should be opened only by qualified service personnel.
6. Disconnect the equipment from all power outlets before cleaning. Use only a damp cloth to clean Advantech HMI PPC-174T-BARE-C Protective Film HMI Touch Glass. Do not use liquid or spray detergents.
7. Position the power cord so that people cannot step on it. Do not place anything over the power cord.
8. Never pour any liquid into an opening. This may cause fire or electrical shock.
9. If the equipment is not used for a long time, disconnect it from the power source to avoid damage from transient overvoltage.
10. Do not leave Advantech screen PPC-174T-BARE-C Touch Panel Front Overlay in an environment with a storage temperature of below -20 °C or above 60 °C as this may cause damage. The equipment should be located in a controlled environment.
11. Read these safety instructions carefully.