M2I X TOP-E Series XTOP10TV-ED-E Overlay Touch Panel

Order each part separately is available

Installation and Panel Cut Size of M2I X TOP-E Series XTOP10TV-ED-E Protective Film HMI Panel Glass

For mounting product to the control panel, it should be recommended following below items. Make a panel cut which XTOP10TV-ED-E Touch Digitizer Front Overlay is mounted and insert product to the panel form the front side. Installation methods should be following by using the supplied installation Clamp 4PCS.
1. Insert the product into the XTOP10TV-ED-E Protective Film Touch Membrane Panel Cut(mounting place). Attach the installation clamps to the installation slot of the product and secure the product to the Panel Cut(mounting place) with screw driver.
2. If the screw is over tightened, it may cause the front deformation, thus resulting the touch sensor can't work properly.
3. Make the Panel Cut (Mounting Size) per each X TOP-E series before install the M2I XTOP10TV-ED-E Touch Screen Display Front Overlay product.

Periodic Check Points

Check the followings periodically for best condition of the XTOP10TV-ED-E Touch Screen Glass Protective Film.
Environment
a.Is the operating temperature within the allowable range (-10C~50C)?
b.Is the operating humidity of XTOP10TV-ED-E Touch Panel Protective Film within the allowable range (10%~80%RH)?
c.Is the Surrounding pollution no corrosive gas?
Power
Is the input voltage within the change range (-15%~+10%)?
Related Items
a.Check the guarantee duration of LCD Backlight of XTOP10TV-ED-E Front Overlay Touch Screen Tablet by eye.
b.Check the touch pad there is no damage, scratch or pollution by eye.