Hakko V710T Touchscreen V710TD Film Housing Repair

FAQ:

Question: How to set V710T V710TD Date and Time?

Answer:
1. Move the cursor using the [←] / [→] switch, and change the value by pressing the [+] / [−] switch.
2. When the desired date and time are set, press the [Set] switch to determine the setting.
3. The calendar data is updated as set.

Question: If a touch switch does not activate at all or if an operation is performed without pressing any touch switch, what should we do?

Answer:Check that the touch switches on the V7 panel are working properly.
1. Press the [Switch Check] switch. Grids appear on the screen as shown below.

2. Press a position on the panel, and check that the pressed position turns white.
The switch is activated normally when the pressed position turns white.
To move back to the “I/O Test” screen, press the [F4] switch.
To delete white dots press the [F5] switch.

3. If a position different from the pressed position turns white, refer to “Touch Switch Adjustment” on the next page and adjust the touch switch position.

Question: How to transfer Screen Data from a CF Card?

Answer:The procedure of transferring data between the V7 series and a CF card is described below.
1. Mounting the CF card Insert the CF card into the CF card connector at the side of the V7 unit.
* Do not remove or insert the CF card in the later steps.
2. Data selection Select [Screen Data]. When the lamp is red, it is selected.
3. Transfer selection Select [Display <-- card="" display="" --=""> Card] or [Display <--> Card].